Measures, cuts, aligns and fits up pipework and supports ready for welding or mechanical joining, working from isometrics.
Direct answer
Gulf Orbit supplies pipe fitters across Saudi Arabia for piping installation, fit-up and support work on oil and gas, petrochemical, industrial and infrastructure projects.
A welder can only work with the joint presented to them. Poor alignment, wrong gap or an out-of-tolerance bevel produces repair work no matter how good the welder is. This is why fitters and welders are better requested together: when both sit in the same supplied crew under one supervisor, the interface between them is managed rather than argued about.
A pipe fitter installs and fits up in place, on the rack or in the trench. A pipe fabricator works in the shop producing spools from drawings. The rate card lists them separately because the working environment and the skills differ. Say whether the work is site installation or shop fabrication.
Trade, headcount, site location, start date, duration and shift pattern. Anything you can add about site access and permit requirements shortens the next step.
We confirm what is available against your dates and flag anything in the scope that will affect mobilization.
Workers are matched to the trade and to the site conditions — industrial versus building work are not interchangeable, and we do not treat them as such.
Iqama, identification and trade documentation are submitted for your review. Nobody mobilizes before you approve the profiles.
Commercial terms are issued against the confirmed scope. A purchase order is required before mobilization.
Workers are briefed on your site induction, permit-to-work and access requirements before they start.
Attendance, replacement and scale-up handled through a single point of contact for the duration of the requirement.
Iqama, identification and trade documentation are available for client review before mobilization. Where a client requires a specific certification or a trade test before a worker is accepted on site, say so in the requirement and it will be addressed during matching rather than after arrival.
Yes, and it is usually the better request. Send the line list or the scope and a crew shape can be proposed with the fitter-to-welder ratio built in.
Drawing-reading is part of the trade, but the level varies with experience. If your scope is complex or the isometrics are dense, say so in the requirement so it is matched on.
Gulf Orbit provides reliable manpower solutions tailored to your project needs. Our team is ready to assist you with any questions or requirements.
